Table of Contents
Advertisement
TEMPERATURE CONTROL ADJUSTMENT FOR
HIGH ALTITUDE ONLY!
TERMS:
• Cut-out - Temperature sensed by the controller that
shuts the compressor off.
• Cut-in - Temperature sensed by the controller that
turns the compressor on.
TOOLS REQUIRED:
• Phillips head screwdriver
•
5
/
" or 2 mm Allen Key
64
• T-7 Torx Key
A. Unplug or disconnect power to the cabinet.
B. Remove the screws that secure the temperature
control to the inset box, lower right, rear of
cabinet.
C. Pull out gently from cabinet.
NOTE
Mechanical temperature controllers are affected when
functioning at high altitude. The Cut-in and cut-out
temperatures will be colder than when the controller
functions closer to sea level.
Temperature
Control
8
INSTALLATION / OPERATION INSTRUCTIONS
............ www.truemfg.com ............
True Food International Equipment, Inc.
D. For high elevation installations, it may be
necessary to "warm-up" the set points. To make
the adjustment, insert the appropriate tool in each
adjustment screw and turn 1/4 of a revolution
clockwise (to the right). This procedure will adjust
both the cut-in and cut-out about 2°C warmer.
E. Make sure to reconnect the pink wire to proper
spade terminal when reinstalling.
MANUAL DEFROST
(Freezer units only!)
The unit will need to be manually defrost. Unplug unit
until all frost is gone. The manual defrost frequency
will depend on the units usage, environment, and the
amount of frost.
DANFOSS TEMPERATURE CONTROL (High Altitude Only!)
Cut-out Adjustment Screw
Allen (5/64" or 2 mm) (clock-
wise for warmer)
Cut-in Adjustment Screw
Torx (T-7)
(clockwise for warmer)
Compressor
Connection (pink)
Compressor Connection
(pink)
(double terminal)
8
Advertisement
Table of Contents
