Service; Access Ports; Log Server; Anms - Tripp Lite B064-016-02-IP Owner's Manual

Device Management

Service

The Service page is composed of two panels: Access Ports and Log
Server:

Access Ports

If a firewall is being used, the Administrator can specify the port numbers that the firewall will allow. If an invalid port number (or no port
number) is specified, you may be blocked from accessing the B064-Series KVM Switch by the firewall. An explanation of the fields in this
section is given in the table below:
Field Description
Program This is the port number that must be specified when connecting from the AP Windows Client software program. Valid
entries are from 1024–65535. The default is 9000.
HTTP The port number for a browser login. The default is 80.
HTTPS The port number for a secure browser login. The default is 443.
Note: The Access Ports cannot have the same value; you must set a different value for each one. If there is no firewall, the Access Ports settings
will not have an effect on the system.

Log Server

Events that occur on the B064-Series KVM Switch, such as logins and internal status messages, are kept in an automatically generated log file.
In order to install and access the Log Server, the Log Server fields on this page must be filled out correctly. Specify the MAC address of the
computer that the Log Server resides on, and a port number that can be used. The valid port range is 1-65535. The default port number is 9001.
Note: Installation and operation of the Log Server is discussed in the section that begins on page 63.

ANMS

The Advanced Network Management Settings (ANMS) page is used
to set up login authentication and authorization management from
external sources. It is divided into three main panels, as shown in the
figure at right:
46