Rtty (Fsk) Operation; Connecting To A Personal Computer; Connecting To The Tu (Terminal Unit) - Yaesu FTDX101MP Operation Manual

RTTY (FSK) Operation

The FTDX101 is equipped with a RTTY decode function. The RTTY signal may be easily synchronized by
aligning the marker displayed on the TFT screen.
Mark frequency (2125 Hz), SHIFT width (170 Hz), and baudot code (US) can be changed in the Setting
Menu.

Connecting to a Personal Computer

Connect the transceiver and a PC with a commercially available USB cable (A-B) to operate RTTY using
commercially available software and freeware.
To connect to a PC using a USB cable, a Virtual COM port driver must be installed on the PC.
Visit the Yaesu website http://www.yaesu.com/ to download the Virtual COM port driver and Installation Manu-
al.

Connecting to the TU (Terminal Unit)

Connect the RTTY communications TU (Terminal Unit) to the rear panel RTTY/DATA terminal. Be sure to
read the instruction manual of the TU device before connecting it.
PTT
66
ANT 1 ANT 2
GND
To USB port
Commercially available USB (A-B) cable
ANT 1
GND
FSK OUT AF IN
TU RTTY/DATA Jack
N.C. DATA IN (Pin 1)
GND (Pin 2)
GND
DATA PTT (Pin 3)
PTT
SHIFT (Pin 4)
FSK OUT
AF IN DATA OUT (Pin 5)
SQL (Pin 6)
N.C.
EXT SPKR KEY REM METER EXT ALC
A B
LINEAR ACC PTT +13.8V
EXT SPKR KEY REM METER
ANT 2
A B
LINEAR ACC PTT +13.8V
DATA OUT
SHIFT
GND
RS-232C
TUNER
EXT ALC RS-232C
TUNER
DATA PTT