Yaesu FTDX101MP Operation Manual page 127

Declaration of Conformity
Type of Equipment:
Brand Name:
Model Number:
Manufacturer:
Address of Manufacturer: Tennozu Parkside Building, 2-5-8 Higashi-Shinagawa,
This device complies with part 15 of the FCC Rules. Operation is subject to the following two con-
ditions; (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The technical documentation as required by the Conformity Assessment procedures is kept at the
following address:
Company: Yaesu U.S.A.
Address: 6125 Phyllis Drive, Cypress, CA 90630, U.S.A.
Telephone: (714) 827-7600
z Changes or modifications to this device that are not expressly approved by YAESU MUSEN could void the user's
authorization to operate this device.
z This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: ( 1 ) This
device may not cause harmful interference, and ( 2 ) this device must accept any interference including received,
interference that may cause undesired operation.
z The scanning receiver in this equipment is incapable of tuning, or readily being altered, by the User to operate
within the frequency bands allocated to the Domestic public Cellular Telecommunications Service in Part 22.
z The YAESU MUSEN is not responsible for any changes or modifications not expressly approved by the party
responsible for compliance. Such modifications could void the user's authority to operate the equipment.
This device complies with ISED's applicable license-exempt RSS standard ( s ) . Operation is subject to the following
two conditions: ( 1 ) this device may not cause interference, and ( 2 ) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : ( 1 ) l'appareil ne doit pas produire de brouillage, et ( 2 )
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
The Scanner receiver is not a digital scanner and is incapable of being converted or modified to a
digital scanner receiver by any user.
WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE
SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW.
CAN ICES-3 (B) / NMB-3 (B)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy; and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
r Reorient or relocate the receiving antenna.
r Increase the separation between the equipment and receiver.
r Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
r Consult the dealer or an experienced radio/TV technician for help.
122
HF/50MHz TRANSCEIVER
YAESU
FTDX101MP / FTDX101D
YAESU MUSEN CO., LTD.
Shinagawa-ku,Tokyo 140-0002 Japan
DECLARATION BY MANUFACTURER