Installation Of The Oven; Electricals - Omega 60 Series Instruction Manual

GB

INSTALLATION OF THE OVEN

To install the oven into the kitchen a cutout should be made in accordance with the
dimensions shown in figure.
The apparatus is to be fastened to the top by means of the two screws provided in the
kit through the holes made on the oven uprights.
The cabinet in which the apparatus is installed shall be open on the back side to ensure
a sufficient air circulation and prevent overheating.
Leave a gap of at least 200 cm2 (see Fig. 1) for air circulation if the oven is installed in a
column; this is not necessary if the oven is installed under the work top.
As the apparatus is to be fitted in your kitchen furniture, make
sure that all surfaces in contact with the oven can resist a
temperature of approx 90°C.

Electricals

- Absorbed power:
oven top element:........................................... 1200+1000W 230V - 1200+1000W 240V
oven bottom element: .................................... 1100W 230V - 1100W 240V
round element (hot air): .................................. 2300W 230V - 2300W 240V
roasting jack motor: ....................................... 4 W (on some models)
lamp: .............................................................. 25 W
hot air fan motor:............................................ 25 W
cooling fan motor:........................................... 25 W
- Maximum absorbed power: (see data plate).
- Supply voltage: (see data plate).
This appliance is in compliance with following European directives:
2006/95/CE (LVD), 2004/108/CE (EMC), 2011/65/CE (RoHS),
2012/19/UE (WEEE), 2002/40/CE.
4
WARNING
(on some models)
NOTE