Omega 60 Series Instruction Manual page 9

Connection to the electrical power mains
The oven is only for domestic use.
The feed voltage and the absorbed power are as indicated on the data plate attached to
the left-hand side upright, which can be seen when the oven door is open.
Connecting must be carried out by qualified personnel and in accordance with the
regulations currently in force.
The manufacturer can not be held responsible for any damages to persons or objects
caused by failure to observe these instructions.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
The oven must be connected to the mains through a multipole circuit breaker with
a contact-to-contact gap of at least 3 mm, making sure that the earth wire is not
disconnected. For connecting use a flexible cable remembering to make it long enough
to allow the oven to be removed from its housing unit when maintenance work is
required.
This apparatus must be earthed.
CABLE TYPES AND MINIMAL DIAMETERS
H05RR-F 3x1,5 mm
H05VV-F 3x1,5 mm
H05RN-F 3x1,5 mm
H05V2V2-F 3x1,5 mm
WARNING
SASO
H05RR-F 3x2,5 mm
2
H05VV-F 3x2,5 mm
2
H05RN-F 3x2,5 mm
2
H05V2V2-F 3x2,5 mm
2
GB
2
2
2
2
7