Angelcare AC117 Owner's Manual page 9

2.2 POWERING THE MOVEMENT SENSOR PAD
1) When using the Sensor Pad for the first time,you will need to insert the
provided CR3032 battery.
2) Remove the battery cover using a coin. Turn in the direction of the
arrow.
3) Place the included battery (CR3032) in the compartment.
Note: The + symbol should be facing up.
4) Replace the battery cover (the two dots will line up).
The Sensor Pad is now ON.
5) Verify the wireless sensor pad is in linking with NU- NU Light Ring
does not flash in light blue.
INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
Angelcare
PAD
2.3- INSTALL THE SENSOR PAD ON THE MATTERESS SUPPORT
IMPORTANT
If your crib does not have a solid, stable surface for the Sensor
Pad, you will need to place a support under it, to ensure correct
operation of the system.
This hardboard support should be at least 6 mm thick and should
have minimum dimensions of 13'' x 13'' (33 x 33 cm). This support
board must be larger than the Sensor Pad surface area.
The Sensor Pad functions with any size and type of mattress except memory-foam
mattresses, hollow frame mattresses and water beds. The hardboard maintains a
constant pressure on the Sensor Pad, enabling it to detect the baby's movements even
when the baby is at the edges of the crib.
PAD
MATTRESS
2
1) Remove the mattress from the crib.
2) Place the Sensor Pad-printed side up-
in the center of the mattress. It should
be centered on the hardboard if your
crib requires a hardboard support.
3) Replace the mattress.
Hardboard
E
N
9