Angelcare AC117 Owner's Manual page 23

Baby sound and movement monitor

Hide thumbs Also See for AC117:

WEAK RECEPTION

• Bring units closer together.

• Change the position of one or both units.

• Place units on a flat surface away from baby's reach.

• Replace the batteries or recharge the Parent Unit.

STATIC, DISTORTION, INTERFERENCES (FROM OTHER

MONITORS, WIRELESS PHONES, WALKIE-TALKIES, ETC...)

• Rotate the Parent Unit or move it away from source of interference.

FEEDBACK (LOUD NOISES EMITTED FROM THE PARENT UNIT)

• Move units farther apart (at least 3 meters apart).

• Decrease volume on the Parent Unit.

THE PARENT UNIT SCREEN IS BLACK (PARENT UNIT IS OFF)

• Turn the Parent Unit back ON by pushing and holding the power button.

• Replace the batteries or recharge the Parent Unit.

SENSOR PAD LIGHT INDICATOR FLASHING RED

(MONITOR IS BARELY DETECTING MOVEMENT)

• Make sure there is no bedding between the mattress and the Sensor Pad.

• The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring

or slat base, place a hard board between the crib base and the Sensor Pad measuring

at least 13'' x 13'' (33 x 33 cm) thick.

• Make sure Sensor Pad is positioned as described under the setup requirements.

Sensitivity may need to be adjusted, refer to Step 5.4.

NO POWER

• Check or replace batteries.

• Make sure Monitor is ON.

NURSERY UNIT POWER ON INDICATOR (GREEN LIGHT) DOES NOT LIGHT UP

• Check connections or change to another electrical outlet.

• Press the Nursery Unit ON/OFF button for 2 seconds to turn the Nursery Unit ON.

Table of Contents