Angelcare AC117 Owner's Manual page 15

SET THE TIC FUNCTION
Allows you to detect baby's movements as well as hear a TIC sound at each movement.
(This function can ONLY be activated in conjunction with the Movement Function).
IMPORTANT
To activate the ''TIC'' Function, the movement detection needs to be ON.
4
7
6
TO TEST THE SENSOR PAD
MOVEMENT MODE NEED TO BE ACTIVATED:
1
MOVEMENT ALARM
• If NO movement is detected after 15 seconds you will hear
a single 'TIC' pre-alarm sound from the Nursery Unit.
• If after a further 5 seconds there is still NO movement
detected both the Parent Unit and Nursery Unit speakers
will emit loud warning sound.v
• Nursery Unit will flash red light.
• Sensor Pad Icon and sound level bar on Parent Unit will flash.
5
2
4) If you have activated the movement,
the Parent Unit will allow you to set
the ''TIC'' function.
The movement
monitoring and
"TIC'' icons will blink
5) Use the UP and DOWN arrows to
set the TIC function.
6) Press the OK button to confirm
your choice.
7) Press the EXIT button to test the
Sensor Pad.
1) Move your hand lightly on the mattress.
NOTE:
The Parent Unit will emit a
''TIC'' sound (when activated) and
will flashes every 5 seconds.
2) Remove your hand from the mattress.
After 15 seconds you will hear a
'TIC' pre-alarm sound, and 5 seconds
later the Movement Alarm will trigger.
3) Repeat by moving your hand lightly
in all four corners of the mattress.
Ensure the Nursery Unit Movement
Indicator is still flashing.
E
N
15