Angelcare AC117 Owner's Manual page 5

16.9 DO NOT attempt to recharge batteries
provided with or identified for use with this
product that are not intended to be charged. The
batteries may leak corrosive electrolyte or explode.
16.10 DO NOT attempt to rejuvenate the batteries
provided with or identified for use with this
product by heating them. Sudden release of
battery electrolyte may occur, causing burns or
irritation to eyes or skin.
16.11 If and when necessary, the batteries must be
replaced with identical new ones or equivalent (volts
and size). If a battery to be replaced is connected
with other batteries in series, replace the other
batteries at the same time as well. DO NOT mix
old and new batteries.
16.12 Reverse polarity installation of the batteries
in the end product must be avoided. Reverse
insertion of batteries can cause charging, and
that may result in leakage or explosion.
16.13 Remove batteries from this product if you
store the product over 30 days because the
batteries could leak and damage the product.
16.14 Discard 'dead' batteries as soon as possible
since 'dead' batteries are more likely to leak in a
product. If a battery has leaked or vented, it should
be replaced immediately using protective gloves.
16.15 DO NOT store this product, or the
batteries provided with or identified for
use with this product, in high-temperature
areas.
WARNING
(North America Only)
17. M o d i f i c a t i o n s n o t
manufacturer may void users authority to operate
this device.
17.1 NOTE: This equipment has been tested and
found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
17.2 However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment OFF and ON, the user
is encouraged to try to correct the interference ­
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
a u t h o r i ze d by t h e
17.3 This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
17.4 This device complies with the part 15 of the
FCC Rules and the Industry Canada license -
exempt RSS standards(s). Operation is subject
to the following two conditions:
17.5 ( 1) This device may not cause harmful
interference, and
17.6 (2) This device must accept any interference
received, including interference that may cause
undesired operation.
IC WARNING:
1. This device complies with Industry Canada
RSS standard(s). Operation is subject to
the following two conditions:
(1)this device may not cause interference,
and (2) this device must accept any inter-
ference including interference that may cause
undesired operation of the device.
2. Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
Lepresent appareil est conforme aux CNR
d'Industrie Canada applicable aux appareils
radio
Exempts de licence. L'exploitation est autorisee
aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioelectrique subi, meme si le
brouillage est susceptible d'en compromettre le
fonctionnement.
E
N
5