Table of Contents
Advertisement
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
2
Install the removed accessories in the
opposite sequence.
12.4 Catalytic cleaning
The cavity with a catalytic coating is self-
cleaning. It absorbs fat.
Before you turn on the catalytic cleaning:
• remove all the accessories .
• clean the oven floor with warm water
and mild detergent.
• clean the inner door glass with warm
water and soft cloth.
1. Set the function
2. Set the maximum temperature and
let the oven operate for 1 hour.
3. Turn off the oven.
4. When the oven cools down, clean
the cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
12.5 Cleaning the oven door
The oven door has two panels of glass
installed one behind the other. To make
the cleaning easier remove the oven
door.
WARNING!
The oven door can close if
you try to remove the
internal panel of glass when
the door is still assembled.
Do not loosen the screws.
1. Open the door fully.
.
2. Lift and turn the levers on the two
hinges till they stop (until you reach
the pins).
Avoid placing the levers in
the vertical position and
make sure both of them are
pulled maximally towards
you.
ENGLISH
19
Advertisement
Table of Contents
