Quick Start; Communication Between Normal Node And Coordinator - Ebyte E70-433NW3S0 User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd

8.Quick start

8.1 Communication between normal node and coordinator

Coordinator configuration
Open the serial port assistant, select the serial port corresponding to the device, and set the serial port parameters
(default is 115200, 8N1)
Enter "+++" without line breaks to enter the AT command mode. When receiving "Enter AT Mode", the AT mode is
successfully entered. As shown in Figure 5-1:
Enter "AT+HELP" with line breaks to see all instructions. As shown in Figure 1:
Then enter "AT+WMCFG=0" with line breaks to configure the device as the coordinator mode, as shown in Figure
2:
Then enter "AT+RSTART" to restart the device with a line break. The coordinator configuration is complete. As
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2019，
Figure 1
Figure 2
E70-433NW30S user manual
12