Transparent Transmission; 5、Quick Start - Ebyte E104-BT10 User Manual

Chengdu Ebyte Electronic Technology Co., Ltd
2、Delete node control：

4.3.3 Transparent transmission

E104-BT10 supports transparent transmission of user data. The maximum length of serial port sub-package is 80
bytes. (Mesh under-transport single-package maximum payload is 8 bytes. Data larger than 8 bytes will be automatically
sub-packet and sent. The whole mesh network efficiency is not high in packet transmission. it is recommended to send
data within a single limit of 8 bytes), the data format is as follows:
Command （1 byte） Target address（2 byte）
Command （1 byte） Target address（2 byte）
For example：device 0001 send hex data "00112233445566778899" to device 004
Transmitting
Receiving
5、Quick start
This chapter introduces how E104-BT10 forms network，and how to control transmitting and receiving of network
message.
5.1 Restore factory setting
Send the following command 02 C0 15 (Restore factory setting) Then there are a return, 03 43 15 00 (sometimes the
value returned after restarting or restoring the factory may be one more byte, ignore it. See the FF of the mesh device as
shown below)
Baud rate: 115200, 8N1, do not press enter to start new line.
hengdu Ebyte Electronic Technology Co., Ltd
Copyright ©2012–2019，C
level without latency
Request 09 C1
Respond 08 41
Remove nodes with main address 0004 out of current network
（E104-BT10-G starts control）
Request
05 C1 00 04 80 49
Respond
07 41 00 0B 00 01 80 4A
Transmitting
0xC2 Main address of target
0x42 Main address of target
09 C2 0004 00112233445566778899
08 42 0004 0001
0004 8202 00000000
0004 0001 8204 00
Data
Valid data
device
Receiving
Original address
（2 byte）
Main address of
device original device
00112233445566778899
E104-BT10 User Manual
Data
Valid data
4-21