Hardware Design - Ebyte E70-433NW3S0 User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd
Example：AT+ECHO=1
Note： This setting only applies when the power is turned on. After the restart, the default settings are restored and the echo is enabled by default.
AT+VER Reading the version number
19
AT+VER
Example：AT+VER
AT+CLINFO Clearing network information
AT+CLINFO
20
Example：AT+CLINFO
Note: The network cannot be re-established after the module is cleared (this command can clear all the information when the number of
coordinator node devices reaches 50).
AT+TLCFG Setting/Querying the concurrency performance parameter (reboot valid)
AT+TLCFG=？
AT+TLCFG=value
21
Example: AT+ TLCFG =0
(Note: This parameter is mainly used to configure the concurrency performance of the module. That is, when various nodes concurrently
transmit data, the maximum number of nodes is supported. The higher the performance, the greater the number of concurrent systems, but the
delay in sending data. The average power consumption of the nodes will increase; the lower the performance, the higher the real-time
performance of the data sent by the nodes, but the data may be lost when the environment has large interference or multiple nodes transmit
simultaneously.)

10. Hardware design

It is recommended to use a DC stabilized power supply. The power supply ripple factor is as small as possible, and

the module needs to be reliably grounded.；
Please pay attention to the correct connection of the positive and negative poles of the power supply. Reverse

connection may cause permanent damage to the module；
Please check the power supply to ensure it is within the recommended voltage otherwise when it exceeds the

maximum value the module will be permanently damaged；
Please check the stability of the power supply, the voltage can not be fluctuated frequently；

Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2019，
Description:
Description:
Description:
Gets the concurrency performance parameter
Response：
TLCFG:0
Description:
Value:0~3
0：Low concurrency
1：Medium concurrency
2：High concurrency
3：Highest concurrency
E70-433NW30S user manual
20