Erasinga User Program; User Program Example - Orton MILL IRON TOOLS Arrow Springs AutoFire ASC/6 User Manual

The controller will advance to STRT. The programmed firing schedule is automatically stored and ready
to START the firing.
If the Delay Start feature is active, the display will show DELA alternating with a Time value. use the
9.
Increase or Decrease key to set a time for the kiln firing to begin. Time is shown as (Hours.Minutes). If no
Delay is needed, set zero hours and zero minutes (00.00). Then press the Program/Start key.
Press the Program/Start key to begin the firing.
10.
Erasing A User Program
If you enter a zero value for a rate (RA #), all settings beyond that point will be erased. This feature can be used to
erase an entire user program by entering a zero rate at RA 1.

User Program Example

Use Program #1 (Bead Annealing)
To fire to 960ºF at 1500ºF/hour
30-minute hold at temperature
Cool down to 500ºF at 100ºF/hour
Shut off.
Follow these steps: starting with the controller at
Press
................................................. A program group
.................................................. USER
.................................................A program number
.................................................PR01
................................................... RA 1 / 0
................................................... 1500
AF4X Kiln Controller
IDLE.
11
Display Shows