Table of Contents
Advertisement
2. Getting started
2.1
Baby unit battery installation
The camera uses either 3 AA size batteries (non-rechargeable batteries
recommended) or the household mains electricity. The Baby unit has no
charging function!
IMPORTANT
The non-rechargeable batteries for the Baby unit are not supplied with
your product. We recommend that batteries be installed before use, so
that the unit continues to work in the event of a power supply failure.
1. Loosen the screw in a counterclockwise direction using a small
screwdriver. Remove the battery cover.
2. Install 3 AA non-rechargeable batteries following the polarity as
shown in the compartment. Close the battery compartment and
tighten the screw in a clockwise direction.
3. Slide the power switch to the
in green.
To switch off the baby unit, slide the power switch to the
NOTE
When the battery level is low, the power LED will turn orange and will flash.
WARNING
Do not mix old batteries with new ones.
Keep batteries away from small children.
Do not short-circuit batteries or dispose of in fire.
Remove the batteries if this device is not going to be used for a long
period of time.
Getting started
ON
position. The power LED will light up
OFF
position.
7
Advertisement
Table of Contents
