Terminal Assignment And Contact Description - EUCHNER MGB-L0 AR Series Operating Instructions Manual

Operating Instructions Safety Systems
MGB-L0...-AR.-... and MGB-L0...-AP.-...
11.8.

Terminal assignment and contact description

Figure 15: Connections and LEDs
Terminal Designation
X3.1 to X3.3 -
X3.4 UA
X3.5 0V
X3.6 -
X3.7 -
X3.8 -
X4.1 FI1A
X4.2 FI1B
X4.3 -
X4.4 FO1A
X4.5 FO1B
X4.6 RST
X5.1 OD
X5.2 OT
X5.3 -
X5.4 OI
X5.5 0V
X5.6 UB
X2.1 to X2.8 -
X1 -
Table 2: Terminal assignment and contact description
26
Description
See the enclosed data sheet
Power supply for monitoring outputs and cover assembly, DC 24 V, must be permanently present.
Ground, DC 0 V (connected internally to X5.5).
Not used
Not used
Not used
In case of AR configuration: Enable input for channel A, connect to DC 24 V in separate operation. In case of switch chains, con-
nect output signal FO1A from previous device.
In case of AP configuration: Input is not evaluated.
In case of AR configuration: Enable input for channel B, connect to DC 24 V in separate operation. In case of switch chains, con-
nect output signal FO1B from previous device.
In case of AP configuration: Input is not evaluated.
See the enclosed data sheet
Safety output channel A, ON when door is closed and bolt tongue is inserted.
Safety output channel B, ON when door is closed and bolt tongue is inserted.
Reset input, device is reset if DC 24 V is applied to RST for at least 3 s.
Door monitoring output,
ON when the door is closed.
Bolt tongue monitoring output,
ON when the door is closed and the bolt tongue is inserted in the interlocking module.
Not used
Diagnostics monitoring output,
ON when the device is in the fault state.
Ground, DC 0 V
(connected internally to X3.5).
Power supply, DC 24 V
See the enclosed data sheet
Reserved for connection of the cover circuit board (only for populated covers)
LEDs
DIA
State
Power
(translation of the original operating instructions) 2112657-13-05/18
RD
GN
GN