Escape Release (Optional); Preparing Escape Release - EUCHNER MGB-L0 AR Series Operating Instructions Manual

Operating Instructions Safety Systems
MGB-L0...-AR.-... and MGB-L0...-AP.-...

7.6. Escape release (optional)

The escape release is used to open a guard from the inside without tools.
Important!
Ì It must be possible to actuate the escape release manually from inside the protected area without
tools.
Ì It must not be possible to reach the escape release from the outside.
Ì The actuator must not be under tensile stress during manual release.
Ì The escape release meets the requirements of Category B according to EN ISO 13849-1:2008.
Ì Fit escape release such that operation, inspection and maintenance are possible.
Ì The actuation axis for the escape release must be inserted min. 10 mm into the handle module. Note the information on
the different profile widths in the next chapter.
Ì Align escape release axis at right angles to the handle module. See Figure 4 and Figure 7.

7.6.1. Preparing escape release

(also see Figure 6: Preparing escape release on page 15)
Profile width Length required for actuation
axis
Without plates
D D+13
30 mm 43 mm
40 mm 53 mm
45 mm 58 mm
50 mm 63 mm
14
Which EUCHNER parts are required?
With mounting
plates
(4 mm each)
D+21
51 mm Standard escape release
with 110 mm axis
(order no. 100465)
61 mm Standard escape release
with 110 mm axis
(order no. 100465)
If necessary,
extended actuation axis (order no. 106761)
66 mm Standard escape release
with 110 mm axis
(order no. 100465)
and
extended actuation axis (order no. 106761)
71 mm Standard escape release
with 110 mm axis
(order no. 100465)
and
extended actuation axis (order no. 106761)
Necessary work steps
Shorten to required length
Without mounting plates:
None
With mounting plates:
Use long actuation axis and protective sleeve and short-
en to required length
Use long actuation axis and protective sleeve and short-
en to required length
Use long actuation axis and protective sleeve and short-
en to required length
(translation of the original operating instructions) 2112657-13-05/18