Press Configure softkey in the Setting and Measurement screen. Configure as follows:
Config 1(default) → Config 2 → Limits
Press Config 2 softkey to enter the Configuration 2 setting page. Use the arrow key (▲
▼) to move the cursor to the External Ref., then press the ENTER key to change value.
Select the Amp softkey and press ENTER to save the setting.
Figure 59 - Configuration 2 Amp mode
Press ESC to go back to the Setting and Measurement screen. Set the arbitrary
waveform generator, to output 6Vrms / 60Hz sine wave, then press On/Off key to start
the output. If the AC output voltage range is 150V, the output voltage will be 150Vrms.
67