Table of Contents
Advertisement
yellow boxes when no entries are stored in any List.
Refer to Error! Reference source not found.. Use the arrow key (▲ ▼) to move the
cursor to the wanted parameter of List Step Configuration page. Press the ENTER key to
change its value, then press the ENTER key again to confirm the change.
After all of the values from have been entered, press the Add Step softkey to enter all
the changes in to memory and create a new step in List No. 0. The Empty Step will
change to 99 and Current Step will change to 1.
Figure 19 - List Mode second page
Parameters
Volts (rms) Start
Volts (rms) End
Volts (DC) Start
Volts (DC) End
Freq. (Hz) Start
Freq. (Hz) End
Time (ms)
Steps
Figure - List 0, User Step 1 Values
Figure 20 – List Mode Add Step
Refer to Figure 21 - List 0, Step 2 Values
23
Values
80
0
0
0
50
50
100
5
Advertisement
Table of Contents
