. Use the arrow keys (▲ ▼) to move the cursor to the wanted parameter of List Step
Configuration page. Press the ENTER key to change its value, then press the ENTER key
again to confirm the change.
After all of the values have been entered, press the Add Step softkey to enter these
changes in to memory and add a new step in List No. 0. The page with Empty Step field in
yellow will change to 98 and Current Step to 2.
After all of the values have been entered, press the Add Step softkey to enter these
Parameters
Volts (rms) Start
Volts (rms) End
Volts (DC) Start
Volts (DC) End
Freq. (Hz) Start
Freq. (Hz) End
Time (ms)
Steps
Figure 21 - List 0, Step 2 Values
Figure 22 - Add New Step
Parameters
Volts (rms) Start
Volts (rms) End
Volts (DC) Start
Volts (DC) End
Freq. (Hz) Start
Freq. (Hz) End
Time (ms)
Steps
Volts (rms) Start
Volts (rms) End
Table 8 - List Mode Parameters
24
Values
60
0
0
0
50
50
60
3
Settings
40
0
0
0
50
50
20
2
40
0