Conversion Kit From Ng To Propane/Ulpg Using Sit 845 Nova Gas Valve - Regency Fireplace Products Greenfire GF1500L Owners & Installation Manual

installation

Conversion Kit from NG to propane/ULPG Using SIT 845 NOVA Gas Valve

Refer to instructions provided with conversion kit for most up to date instructions.
FOR GF1500L-2 PART #607-967 USING SIT 845 NOVA GAS VALVE
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
Each Kit contains one Propane / ULPG
Conversion Kit
Qty. Part # Description
1 904-431 Burner Orifice#49 ULPG
1 904-434 Burner Orifice #47 LP
1 918-590 Decal "Converted to LP"
1 919-728 Orange Propane Label
1 918-272 Conversion to ULPG decal
1 904-529 5/32" Allen Key
1 910-037 Injector Orifice LP #30
1 919-727 Red Universal LPG label
1 920-355 Instruction Sheet
1 911-328 Pressure Switch
1 911-240 Brown Connecting Wire
1 920-356 Propane/ULPG Wiring Diagram
IT WOULD BE BENEFICIAL TO CONVERT THE APPLIANCE PRIOR TO
THE UNIT BEING INSTALLED OR WALL FACING MATERIAL FITTED
WHICH ALLOWS ACCESS TO THE BOTTOM PANEL.
PRIOR TO CONVERSION, ENSURE UNIT HAS COOLED TO ROOM
TEMPERATURE, ALL POWER IS DISCONNECTED AND GAS SUPPLY
IS TURNED OFF.
1. Remove faceplate, glass door, front trim piece- see instructions in this
manual.
2. Remove logs.
3. Remove burner side panels by lifting out as shown in Diagram 1.
4. Remove inner panels.
Diagram 1 - Burner Side Panels
5. Remove rear log tray by removing 3 screws as shown in Diagram 2 below.
Diagram 2 - Rear Log Tray Screw Locations
6. Unscrew the 2 front NG log pins. Relocate those pins to the rear holes
and reinstall.
Propane/ULPG
Natural Gas
920-355
42 |
Greenfire® GF1500L-2 Gas Fireplace
CONVERSION KIT FROM NG TO PROPANE/ULPG
IF IN DOUBT DO NOT DO THIS CONVERSION !!
7. Remove burner by removing 3 screws in locations shown
below.
Diagram 3 - Burner Screw Locations
8. Pull off the pilot cap to expose the pilot orifice (see below).
Pilot Orifice
.
9 Unscrew the pilot orifice with the Allen key and replace with
the propane/ULPG pilot orifice in the kit and replace pilot cap
(see right).
10. Remove burner orifice with a 12mm spanner and discard. Use
another spanner to hold on to the elbow below the orifice.
1
GF1500L-2
Pilot Cap
Diagram 4 - Remove Pilot Cap
11/26/20