Connecting The Sf61B To An Intermec Sd61 Base Station - Intermec SF61BUG User Manual

Chapter 2 — Connecting the SF61B
Connecting the SF61B to an Intermec SD61 Base
Station
28
Note: If your scanner is configured for the HID Bluetooth profile
when you try to connect to the SD61 base station, the connection will
not succeed. If in doubt, read the following bar code (SPP is the
default profile) to make sure that your scanner is not HID-enabled:
Bluetooth Device Profile - SPP (*)
Note: You cannot use your SF61 product to change the setup of the
SD61 base station, to do this you must use an SF51 scanner or using
EasySet online setup (see the SD61 documentation for more
infomation).
To connect up to 7 scanners
1 Connect the SD61 base station to a host device (the host PC of
your data management application for example).
See the SD61 Base Station User's Guide available on the Intermec web
site at www.intermec.com
SD61.
2 With each scanner you want to connect, scan the association bar
code label on the SD61 base station and wait for the connection to
be established.
The scanner beeps twice, the green status light flashes twice and
the blue Intermec Ready-to-Work indicator starts blinking. When
the scanner connects to the base station it emits a series of beeps
from low to high. The blue Intermec Ready-to-Work indicator
turns on and stays on for both the scanner and base station.
Note: You may have to wait a few seconds for the scanner to connect
(blinking blue Intermec Ready-to-Work indicator).
for details on how to connect your
SF61 Cordless Scanner User's Guide