Intermec SF61BUG User Manual page 25

SF61 Cordless Scanner User's Guide
To scan with an SF61B 1D imager model
1 Turn your scanner on by pressing the scan button.
2 Connect your scanner to a Bluetooth device.
3 Point the SF61B at the bar code and hold the SF61B at a slight
angle 5 to 10 cm (2 to 4 in) from the label.
4 Press the scan button and direct the red beam so that it falls across
all the bars in the bar code label.
Use this test bar code:
Code 39 Test Bar Code
*123456*
*123456*
Tip: Depending on your screen resolution, you may be able to scan
bar codes displayed on your computer screen.
By default, when the SF61B successfully reads a bar code label, it
beeps once, the status light briefly turns green, and the scanner
beam turns off. If Vibrate Alert is enabled, the SF61B briefly
vibrates.
5 Release the scan button.
*
M E C
T E R
* I N
Scanning Bar Codes (example showing a 1D scanner): The aiming and
scanner beams that you see depend on the SF61B model you are using.
To scan with the SF61B2D and SF61BHP
1 Turn your scanner on by pressing the scan button.
2 Connect your scanner to a Bluetooth device.
Chapter 1 — Introducing the SF61B Cordless Scanner
15