Stopping The Engine - Hisun HS 200UTV-2 Owner's Manual

Table of Contents

Advertisement

Introduction HS 200UTV-2/HS 250UTV-2
5. Turn the key to the "START" position
and release when the engine starts.
IMPORTANT:
Because of safety devices, the engine will
not start except when the gear shift lever
is placed in the "NEUTRAL" position and
the brake is depressed.
■ Cold Starting
When the ambient temperature is below -
15℃( 5℉), the engine is very cold. If the
engine fails to start after 5 seconds, turn
off the key for 30 seconds and start again.
■ Cold Starting
When the ambient temperature is below -
15℃( 5℉), the engine is very cold. If the
engine fails to start after 5 seconds, turn off
the key for 30 seconds and start again.

STOPPING THE ENGINE

1. After slowing the engine to idle, turn the
key to "OFF".
2. Remove the key.
WARMING UP
CAUTION:
To avoid personal injury:
Be sure to set the parking brake during
warm-up.
Be sure to set the shift lever to the
"NEUTRAL" position during warm-up.
For 5 minutes after engine start-up, allow the
engine to warm up without applying any load.
This is to allow oil to reach every engine part. If
load applied to the engine without warming-up,
troubles engine damage may occur.
■ Warm-Up Transmission Oil in the Low
Temperature Range
IMPORTANT:
Do not operate the vehicle under full load
until it is sufficiently warmed up.
1-24

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hs 250utv-2

Table of Contents