Tcp Server Mode - Moxa Technologies NPort IA-5150-M-SC User Manual

Table of Contents

Advertisement

NPort IA5150/5250 Series User's Manual
ATTENTION
The driver used for Real COM Mode comes with the NPort IA5150/5250 NPort Administrator.
The driver is installed automatically on your computer when you install NPort IA5150/5250
Administration Suite.
One of the major conveniences of using Real COM Mode is that Real COM Mode allows users to
continue using RS-232/422/485 serial communications software that was written for pure serial
communications applications. The driver intercepts data sent to the host's COM port, packs it into
a TCP/IP packet, and then redirects it through the host's Ethernet card. At the other end of the
connection, the NPort IA5150/5250 accepts the Ethernet frame, unpacks the TCP/IP packet, and
then transparently sends it to the appropriate serial device attached to one of the NPort
IA5150/5250's serial ports.
ATTENTION
Real COM Mode allows several hosts to have access control over the same NPort IA5150/5250.
The driver that comes with your NPort IA5150/5250 controls host access to attached serial
devices by checking the host's IP address. Refer to Accessible IP Settings in Chapter 5 for more
details.

TCP Server Mode

In TCP Server mode, NPort IA5150/5250 is configured
with a unique IP:Port address on a TCP/IP network.
NPort IA5150/5250 waits passively to be contacted by
the host computer, allowing the host computer to
establish a connection with and get data from the serial
device. This operation mode also supports up to 4
simultaneous connections, so that multiple hosts can
collect data from the same serial device—at the same
time.
As illustrated in the figure, data transmission proceeds as
follows:
1. The host requests a connection from the NPort
IA5150/5250 configured for TCP Server Mode.
2. Once the connection is established, data can be
transmitted in both directions—from the host to the
NPort IA5150/5250, and from the NPort
IA5150/5250 to the host.
Choosing the Proper Operation Mode
TCP Server Mode
2
1Request a
connection
2Proceed with
data transmission
4-3
1
TCP/IP
Ethernet
TCP Server
RS-232/422/485
Device

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nport ia5250 seriesNport ia5150 seriesNport-ia-5250Nport-ia-5250-tNport ia-5150

Table of Contents