Htek UC803P Quick Reference

Hardware Overview
LEDs
1. Power Indicator: Steady green when power on, blinking green when the call is ringing.
2. Line Keys
Steady green: during the conversation, or plan to dial a call.
Blinking red: the call is ringing.
Off: idle interface
Place a call
Three ways to make a call:
1) Handset: Pick up the handset; enter the number, and then press the send soft key or
press .
2)Speaker：Press or the line keys; enter the number, and then press the send soft
key or press .
3) Headset: Press ; enter the number, and then press the send soft key or press
Note: You can also use Contacts or call log to dial the number you want, press place
the call by the three ways mentioned. More, you can also alternate the mode
during the call.
End a call
To end a call in three different modes:
1) Handset: hang up the handset or press the cancel soft key.
2) Speaker: press , or press the cancel soft key
3) Headset: press the cancel soft key.
Answer a call
1) Handset: pick up the handset;
2) Speaker: press ;
3) Headset: press .
Note: You can also reject the call by press the Reject soft key.
Hold
Press the hold soft key during a call to hold the call, Resume the soft key to resume the
call.
Call Transfer
Blind Transfer
a. Press the transfer soft key during the conversation, the call is on hold now.
b. Enter the number that transfers to.
c. Press the transfer soft key, and now the blind transfer completed.
Attended Transfer (at least one line key set as Auto)
a. Press the transfer soft key during the conversation, the call is on hold now.
b. Enter the number that transfer to, and press the send soft key or
c. Start the second conversation, press the transfer soft key, then, transfer completed.
Semi-Attended Transfer (at least one line key set as Auto)
a. Press the transfer soft key during the conversation, the call is on hold now.
b. Enter the number transfer to, and then press
c. Press the transfer soft key, and now the Semi-attended transfer completed.
Call Conference
Assuming that A and B are in conversation. A wants to bring C (or D & E) in a conference:
1) A press line 2, the call is placed on hold.
2) A enter the number of C and then press send soft key or
3) A press the conference soft key, then A, B and C are now in a conference.
4) If add D&E, press DSS key 1 (set DSS key as Line key), the current conference is on hold,
.
dial D and press conference soft key, the four are in conference. Press DSS key 2, and dial
E, press conference soft key, then A,B,C,D,E are in conference.
Note:
1) If C does not answer the call, A can back to continue the conversation with B;
2) Once A hangs up the call, the conference is ended, while if B or C drops the call, A&C
or A&B conversation continues.
Call Mute
Press to mute the microphone during the call
Press again to un-mute the conversation.
.
, then you can hear the ring tone.
. C answers the call.