Advertisement
MPD-62M2812P0A
Operating Instructions
Using OSD Controller
Setup menu can be accessed and controlled by OSD control joy stick on the
side of the gimbal. Five commands are available with the joy stick.
The design of OSD could be different according to the Model.
Description of the OSD control operation
1) SET Key (●) : Access to the menu or enter the setting.
To enter the main menu, press the Set Key down.
2) UP/DOWN Key (▲/▼) : Choose the desired sub-menu and to move the
cursor up or down.
3) LEFT/RIGHT Key (◄/►) : Set up the value of the selected menu. Used
to adjust the desired menu selection and to move the cursor left or right.
4) ' 'denotes the long press down straightly for about 2 seconds
Description of the Motorized ZOOM&FOCUS* adjustment
(*) Works only when OSD Menu is inactive.
1) ▲ : Zoom In
2) ▼ : Zoom Out
ANALOG OUT0 should be set to TVI MODE, AHD MODE or CVI MODE
to get CVBS video in sub-out. If it is set to CVBS, there is no CVBS video
in sub-out port. (SYSTEM> OUTPUT> ANALOG OUTPUT0)
If CVBS video is enabled through ANALOG OUT0 or Sub-out port, WDR
and 3D-NR functions are disabled in all video outputs.
It should be considered when installer adjusts the video with installation
monitor via CVBS video signal.
Video sub-out Connector
3) ◄ : Focus Near
4) ► : Focus Far
13
OSD Control Joy Stick
Advertisement
