Assa Abloy Norton SafeZone 7110SZ Installation And Instruction Manual page 9

3 7
Mount Track
If opening angle greater than 125°, spring cushion stop cannot be used and an auxiliary stop
by others is required.
!
Set Screws
toward hinge
1) Insert slider into track.
2) Insert spring cushion stop on hinge side
of track for 125°or less opening angle.
!Do not use for openings greater
than 125°!
3 8
Connect Arm to Track
Open Latch & Sweep Valves
with 1/8" wrench provided.
3 9
Closer Spring Adjustment
Closing Force
Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
C
Secure arm to slider
assembly using 3/16"
Wrench. Turn wrench
counterclockwise to
tighten.
11/16"
Wrench
+
Stronger
A
B
3) Insert end caps (both ends).
4) Secure track to door using provided
screws.
5) Snap on cover.
HINGE
Open door to maximum desired
swing minus 5° and hold. Slide
spring cushion stop assembly
against slider assembly and
secure to track using 5/64" or
2mm wrench.
Weaker
9
D
E
Slowly increase closer power until
door closes consistently.
NOTE: A closer set to the ADA
required 5 lbs opening force may
not be strong enough to close the
door due to latching hardware, air
pressure, or frame issues.
80-9371-0081-020 (01-14)
ASSA ABLOY