Hardware Reset; Network Default Settings; Web Server Default Settings - DEVA Broadcast DB90TX Maintenance And Operation Instruction Manual

Ip audio encoder

Hide thumbs Also See for DB90TX:

Table of Contents

HARDWARE RESET

This process will fully restore DB90-TX to its Factory Defaults, including the Network settings.

Hardware Reset can be done by following the next steps:

• Disconnect the power supply cable from the unit.

• Locate the RESET button on Rear panel.

• Press and hold the RESET button.

• Connect the power supply cable to the unit.

• Keep the RESET button hold until the POWER led starts blinking.

• Release the RESET button.

• Wait for DB90-TX to reboot with the factory default settings.

Upon completion of the process DB90-TX settings will have the following values:

• DHCP: enabled

• Port: 80

• Username: user

• Password: pass

All other settings will have the factory default values described in chapter "Factory Defaults

Settings".

NOTE:

After the process completes the DHCP Client is enabled. The DB90-TX will obtain IP

Address from DHCP server shortly.

ATTENTION:

Please note that the WEB Server's Port, Username and Password will be

changed, so it is possible the page not to be loaded after restoring factory defaults. You may be

asked to re-enter the encoder's address and/or username and password.

65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria

Tel: +359 56 820027, Fax: +359 56 836700

E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com

- 23 -

Table of Contents