Table of Contents
Advertisement
HARDWARE RESET
This process will fully restore DB9000-TX to its Factory Defaults, including the Network
settings. Hardware Reset can be done by following the next steps:
•
Disconnect the power supply cable from the unit.
•
Locate the RESET button on Rear panel.
•
Press and hold the RESET button.
•
Connect the power supply cable to the unit.
•
Keep the RESET button hold until the POWER led starts blinking.
•
Release the RESET button.
•
Wait for DB9000-TX to reboot with the factory default settings.
NOTE:
After the process completes the DHCP Client is enabled. The DB9000-TX will obtain
IP Address from DHCP server shortly. All other settings will have the factory default values
described in chapter "Factory Default Settings".
65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56/820027, Fax: +359 56/836700
- 23 -
E-mail: office@devabroadcast.com
Web: www.devabroadcast.com
Advertisement
Table of Contents
