Hardware Reset; Network Default Settings; Web Server Default Settings - DEVA Broadcast DB9000-TX Instruction Manual

HARDWARE RESET

This process will fully restore DB9000-TX to its Factory Defaults, including the Network
settings. Hardware Reset can be done by following the next steps:
• Disconnect the power supply cable from the unit.
• Locate the RESET button on Rear panel.
• Press and hold the RESET button.
• Connect the power supply cable to the unit.
• Keep the RESET button pressed until the POWER led starts blinking.
• Release the RESET button.
• Wait for DB9000-TX to reboot with the factory default settings.
Upon completion of the process DB9000-TX settings will have the following values:

Network Default Settings

• DHCP: enabled

WEB Server Default Settings

• Port: 80
• Username: user
• Password: pass
All other settings will have the factory default values described in chapter
Settings".
NOTE:
Once the process is completed, the DHCP Client will be enabled. The DB9000-TX will
obtain IP Address from DHCP server shortly.
ATTENTION:
changed, so it is possible the page not to be loaded after restoring factory defaults. You may be
asked to re-enter the encoder's address and/or username and password.
Please note that the WEB Server's Port, Username and Password will be
65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com
- 34 -
"Factory Default