Download Print this page

Troubleshooting - Alarm.Com ADC-V523 Installation Manual

Wi-fi indoor camera

Hide thumbs Also See for ADC-V523:

Troubleshooting

• If you have issues connecting the camera to the

account, power cycle the camera (unplug the power

jack from the camera and then plug it back in to

restore power).

• If issues persist, reset the camera to factory defaults

by using the WPS button located on the back of the

camera. Press and hold the WPS button until the

LED is flashing Green and Red (about 15 seconds),

then release the button. The camera will reboot

with factory defaults. If the camera was previously

installed to an Alarm.com account, it will need to be

deleted before it can be installed again.

Questions?

Visit: www.alarm.com/supportcenter

ADC-V523 Installation Guide

Table of Contents

Do you have a question about the ADC-V523 and is the answer not in the manual?