Alarm.Com ADC-V523 Installation Manual page 4

AP Mode
Add the Camera to an Alarm.com Account
To ensure sufficient Wi-Fi signal, complete these
steps with the camera near its final location but prior
to mounting.
1
Connect the camera's AC power adapter and plug it
into a non-switched outlet.
2
Hold down the WPS button and release when the LED
begins to flash white (about 6 seconds).
3
On an Internet enabled device, connect to the wireless
network "ALARM (XX:XX:XX)" where XX:XX:XX is
the last six digits of the ADC-V523's MAC address,
which is located on the back of the ADC-V523.
4
On the same device, open a web browser and enter
"http://522irinstall" in the URL field. Follow the on-
screen instructions to add the ADC-V523 to the
wireless network. The LED will be solid green when the
connection is complete.
ADC-V523 Installation Guide 3