Alarm.Com ADC-V523 Quick Start Manual

Factory reset to default settings

Hide thumbs Also See for ADC-V523:

Factory reset an ADC-V523 to its default settings

Resetting a video device to its factory defaults removes all programming and memory from the device.

Important: Wait at least two minutes for the video device to power on fully before performing the following procedure.

The factory reset might fail if the device is still powering on.

1. Press and hold

the Reset button

on the bottom of the camera

until the LED is flashing Green

and Red (about 15 seconds),

then release the button.

2. The camera will reboot with

factory default settings.

https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/1080p_Indoor_Wi-Fi_Camera_(AD...

Reset button location

located

The Reset/WPS button

the underside of the camera.

Reset button image

is on

Updated: Sat, 18 Apr 2020 15:27:19 GMT

Table of Contents

Do you have a question about the ADC-V523 and is the answer not in the manual?

Page 1 Factory reset an ADC-V523 to its default settings Resetting a video device to its factory defaults removes all programming and memory from the device. Important: Wait at least two minutes for the video device to power on fully before performing the following procedure.
Page 2 Important: Once a video device has been reset, it is normal for the LED to turn off momentarily. It is best to leave the video device plugged into power and undisturbed for two minutes after performing the factory reset. https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/1080p_Indoor_Wi-Fi_Camera_(AD… Updated: Sat, 18 Apr 2020 15:27:19 GMT...