Ats Control Panel - Hyundai DHY22KSE User Manual

Introduction of AMF10/16 control module
Introduction of iL‐MRS10/16 controller panel as follow
1. Start‐up. Start the engine.
2. Stop. Stop the engine.
3. Reset. Clean failure and alarm state.
4. Horn reset. deactivates the horn
5. Mode left. Change the generator set mode
left‐handed (MEASUREMENT‐AUTO‐MAN‐OFF)
6. Mode right. Change the generator set mode
left‐handed. (OFF‐MAN‐AUTO‐MEASUREMENT)
7. Generator set power on/off. Manual turn on/off the
generator set power switch
8. Generator set failure: red LED starts flashing when
generator set failure occur. After fault reset button
is pressed, goes to steady light (if an alarm is still
active) or is off (if no alarm is active)
9. Generator set voltage present: green LED is on, if
gen voltage is present and within limits
10. Connect generator set power present. Green LED
light, generator set output switch is on, otherwise
the green LED flash.
11. Page. Cyclic selection of the display mode
(measurement adjustment)
12. Up. Select the set point, select the screen or
increase set value point
13. Down. Select the set point, select the screen or
decrease set value point
14. Enter. Confirm the set point value
Introduction of function and operation
MRS10/16 self‐start control module is low a level to
AMF20/25 control module, it is a single module
without mains power measurement function, and
also has less I/O terminals than AMF20/25. Besides,
their other function and operation are similar or
same.
3.7
ATS control panel
3.7.1 ATS panel general introduction
Our customer will need this ATS if generator set is
used for self‐start standby power. In order to achieve
full automatic transfer between mains power and
generator set power to guarantee all load present,
our ATS panel select the best ATS for all generator set.
And to the most possibility to serve our customers'
demand, we prepare two types of ATS: MRS and AMF.
Besides MRS and AMF can be jointed to a double
standby ATS after a little change, which is used for 2
generator sets work together stand by mains power.
Please reference relevant details of ATS for its
function, application, operation and so on.
Safty Attention:
! We are very pleasure for your support of our product,
before you use our ATS please read this instruction
carefully.
We mark three attention parts in accordance with
different situation:
Danger:
! If you do wrong action, Personal death or other big
disaster must be happened.
Moving Attention
Danger :
! When you move ATS by crane or elevator, don't
stand beneath the ATS, to avoid personal death.
Installation Attention
Attention:
! All operators must be professional electrician.
! Cut off all power before installation.
! Fix screw in accordance with TORPUE standard.
! Place ATS on plane in vertical direction.
! Don't install ATS in the environment, where are high
temperature, humidor or filled with corrosion gas.
! Connect neutral pole with "N" pole while you install
4poles of ATS.
Operation Attention
Danger:
! Don't connect energized main circuit or control line
with terminal.
Attention:
! If ATS is tripping, cut off power source, find problem
and solve it at first.
Our company supply ATS panel should use for AMF
series generator control module, from the diagram
you can see it is very easy to connect cable and easy
install ATS panel. Our panel can use in AUTO or
16
User manual