Hyundai DHY22KSE User Manual page 23

MANUAL status.
Manual status operation:
Step 1
You should check the generator control module set in
MANUAL status, then use the operate handle insert
the switch axis.
Step 2
Operating direction of the arrow
Step 3
Check the position on 'A' or 'B'.
AUTO status operation
You can connect the special cable connector with
generator set. Then set the generator module in
AUTO,that is OK!(detail operate step refer module
control system)
ATS PANEL introduction
No MODEL
1 ATS switch
2 panel lock
3 mains power output hole
4 generator power output hole
5 communicate with generator module port
6 load power cable output
7 panel on ground leg
Maintenance, inspect or exchange parts attention:
Attention:
! All operator must be professional electrician.
! Turn switch on "OFF" position, make sure main line
or control line isn't energizing.
! When you want to inspect inside part, make sure
power "A"B" is off, to avoid finger injury.
! Fix screw of terminal in electrical way.
17
User manual