Table of Contents
Advertisement
Installation and connections should only be done by qualified personnel.
Disconnect the negative battery terminal before doing any electrical work.
Some bumpers have factory markings on the inner side; before drilling any holes, make sure they correspond to the recommended positions.
Some bumpers require correction adapters around the sensors to obtain the proper fitting angle.
System performance will depend on the correct positioning and angling of the sensors.
1.
Accurately calculate and mark the sensor positions on the bumper.
2.
Remove the bumper and make sure there are no obstructions that may hinder the fitting of the sensor heads and the control unit (ECU).
3.
Use a small diameter bit to drill pilot holes for each sensor.
4.
Finish the holes to the proper diameter using a cone drill bit that matches the diameter of the selected adapters.
Determine the correct mounting height and position to achieve the best detecting angle and distance (the figures shown below are purely indicative).
6.0 - INSTALLATION PRECAUTIONS
7.0 - PREPARING FOR INSTALLATION
8.0 - INDICATIVE SENSOR SPACING AND HEIGHT
Designed and manufactured by GEMINI TECHNOLOGIES srl ‐ Via L. Galvani, 12 – 21020 Bodio Lomnago (VA) – Italy
Tel. +39 0332 943211 – Fax +39 0332 948080 – www.gemini‐alarm.com
ISO 9001 CERTIFIED COMPANY
Rev.01 07/2018
3/9
Advertisement
Table of Contents
