Table of Contents
Advertisement
The PDC kit is directly Plug & Play connected as follows:
1.
Connect the 6 wires coming out of the control unit to the 6 sensors (the longest wires to the sensors at the opposite end of the control unit).
2.
Connect the connector coming out of the control unit to the corresponding reverse light connector.
10.1 – OPTIONAL CONNECTIONS:
1.
BROWN wire: by connecting this wire to the radio MUTE, volume is temporarily excluded or reduced when an obstacle is detected.
2.
BLUE wire: by grounding this wire (wire can be hooked up to an optional toggle switch), rear sensors can be disabled when towing. The system can also be made to
disable automatically by connecting the trailer plug (if a free pin is available for electrical ground).
3.
YELLOW wire: by grounding this wire (wire can be hooked up to an optional toggle switch), the impact detection zone can be pushed out past the bike (minimum safety
distance (STOP zone) is pushed out approx. 1m). Bike rack mode must be selected before engaging reverse gear. When reverse gear is engaged, 3 audible warnings
(Beep-Bop-Beep) will confirm that the bike rack option is enabled. These beeping tones will be followed by the 2 activation tones.
CAUTION: OBSTACLES BETWEEN THE BUMPER AND THE NEW STOP ZONE WILL NOT BE DETECTED.
10.2 – CHECK AFTER INSTALLATION
ATTENTION: Make sure there are no other conflicting Master devices in use nearby.
1.
Reconnect the negative battery terminal.
2.
Turn ignition key ON and engage reverse gear. Activation will be confirmed by a short Beep.
3.
Test the sensors one by one for detection by moving different obstacle simulators in front them.
Distances and detections are approximate because of the position, size and shape of the objects. For a more accurate detection, test the sensors by placing
the objects at different angles of the sensors field of view.
If needed, the sensor sensitivity can be modified (see configuration table).
4.
If the parking sensors are working correctly, secure the bumper in place.
10.0 – WIRES AND CONNECTIONS
Designed and manufactured by GEMINI TECHNOLOGIES srl ‐ Via L. Galvani, 12 – 21020 Bodio Lomnago (VA) – Italy
Tel. +39 0332 943211 – Fax +39 0332 948080 – www.gemini‐alarm.com
ISO 9001 CERTIFIED COMPANY
Rev.01 07/2018
5/9
Advertisement
Table of Contents
