Table of Contents
Advertisement
Quick Links
INSTALLATION CERTIFICATE
The undersigned qualified installer attests to have personally fitted the here described system following the
manufacturer instructions.
By :
Sold on :
.................................................................
Vehicle :
..........................................................................................................................
GEMINI Technologies S.p.A.
Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia
Tel. +39 0332 943211 - Fax +39 0332 948080
Web site: www.gemini-alarm.com
Type of product :
818W
Reg. n.532-A
UNI EN ISO 9001:2008
KIT Parking
Sensor 818W
INSTALLATION AND
USE MANUAL
UK
AC 2761/UK Rev. 03 - 12/11
Advertisement
Table of Contents
Related Manuals for Gemini KIT Parking Sensor 818W
Summary of Contents for Gemini KIT Parking Sensor 818W
- Page 1 INSTALLATION AND ..............USE MANUAL Vehicle : .......................... GEMINI Technologies S.p.A. Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia Tel. +39 0332 943211 - Fax +39 0332 948080 Web site: www.gemini-alarm.com Reg. n.532-A UNI EN ISO 9001:2008...
- Page 2 GREEN BLACK BLUE 20 x BLACK-BLUE BLUE BLACK BLUE BROWN Sensor 1: front with shortest cable. Sensor 4: front with longest cable. POWER POWER GREEN km/h +12/24V BLACK-YELLOW km/h BLACK-BLUE Sensor 5: rear with BROWN shortest cable. Sensor 8: rear with longest cable.
- Page 3 WINDSCREEN CORRECT POSITION DASHBOARD ALTERNATIVE MOUNTING TECHNICAL SPECIFICATIONS Supply voltage From 9 to 30 Vdc Current consumption when system working 100mA max. Service temperature range From -20°C to +70°C Ultrasound frequency 40Khz Control units and display communication frequency 434Mhz Software version reference (reported on control unit and display) SW06...
-
Page 4: Table Of Contents
USER MANUAL TABLE OF CONTENTS - PRELIMINARY ADVICE.................... PAGE 02 2.0 - SYSTEM OPERATION USER MANUAL Remember to always look around the vehicle while parking. - SYSTEM OPERATION....................PAGE 03 Small obstacles or objects with low reflectance might not be detected. 2.1 - Detection Zones...................... -
Page 5: Rear Sensors
2.2 - REAR SENSORS 3.0 - TROUBLESHOOTING GUIDE The rear sensors are activated when reverse gear is engaged; an audible signal warning and the 3.1 - LOW POWER SUPPLY SIGNAL downward arrow icon that lights up on the display will indicate the sensors are active. If, when the system is turned on, the battery level is too low to guarantee the accuracy of the system, Obstacles are signaled by different audible tones and the lighting up of the relative detection zones after a few seconds, the following icons will be displayed: vehicle, front sensors arrow icon and four... -
Page 6: Others
The warranty will become void if labels are missing or torn, if the installation certificate is not fully compiled or if the enclosed sale document is missing. The warranty is valid exclusively at authorized Gemini Technologies centers. The manufacturer declines any responsability for eventual malfunctions of the parking sensors or any damage to the vehicle electrical system due to improper installation, use or tampering. -
Page 7: Installation Of Sensors
INSTALLER MANUAL 8.0 - INSTALLATION OF SENSORS To install the sensors on a metal bumper, you must use appropriate adapters ( supplied) Choose the suitable type of plastic br acket and mark the center of the holes to drill. For brackets “10” drill holes with a 18mm diameter, for brackets “11”drill holes with a 22mm and for brackets “13”... -
Page 8: Connections
Snap the bracket (13 or 14) in the hole from the outer part of the bumper. 9.0 - CONNECTIONS osition the plastic brackets so that the connector of the sensor comes out horizontally 13 14 +12V Check the wireless communication and the length of the cables before proceeding with the final positioning of the accessories. -
Page 9: Pairing Of Control Units With Display
10.0 - PAIRING OF CONTROL UNITS WITH DISPLAY 12.0 - TESTING To test wireless reception correctly, the control units When pairing, make sure reverse gear is disengaged and no similar control units are activated in the surroundings. MUST be connected one at a time. Turn the ignition key “ON”. -
Page 10: Rogramming
13.0 - PROGRAMMING 14.0 - SETTING OF PARAMETERS PARAMETER RANGE SETTING Only expert users should modify these settings to avoid malfunctions of the parking system. Volume of buzzer 0, 1, 2 ( Ref.1 Detection range of front central sensors From 50 to 95 cm Detection range of rear central sensors From 120 to 180 cm ( Ref.2...