Table of Contents
Advertisement
The following icons will be displayed according to operations.
FRONT SENSORS
DETECTION ZONES
ICONS.
SENSORS
DEACTIVATED
INDICATION ICON.
SENSORS
ACTIVATED
INDICATION ICON.
"STOP" ZONE ICON.
ACTIVATION/DEACTIVATION OF SENSORS,
TURNING OFF OVERSPEED INDICATOR,
SCROLLING AND SETTING OF FUNCTIONS.
On every button press, the sensors will be
activated/deactivated.
The upward arrow icon will be displayed when
the sensors are activated.
6.0 - SETTING OF OVERSPEED AUDIBLE ALERT
This procedure can only be done if the relative cable of the display wiring is connected
to the odometric signal of the vehicle; check with your installer.
!
Turn the ignition "ON".
!
Enter in the programming mode (see chapters
and
set it by keeping one of the two display buttons pressed for about 3 sec.; by activating this
function the display and the speed value will light up every time speed exceeds 15 km/h
!
Turn ignition key "OFF" then "ON" and increse speed.
!
Look at the speed displayed; when the required threshold is reached to set the overspeed audible
alert, press the right-hand display button
!
A series of audible signals will now sound every time the vehicle exceeds the registered speed.
!
To deactivate this function press the left-hand display button when speed exceeds 15km/h; an
audible signal will indicate deactivation.
!
To reactivate this function and set another threshold, press the right-hand side button (even if the
speed is higher than the one actually set, the system will register this last value)
PAGE 06 - USER MANUAL
5.0 - DISPLAY
DISTANCE OF OBSTACLE
INDICATOR
PARAMETER.
STATUS (F or C) AND
SETTING OF PARAMETER
VEHICLE SPEED.
SOFTWARE VERSION.
AUDIBLE WARNINGS
ON/OFF ICON.
S
ETTING MODE
CONTROL UNITS/DISPLAY
SIGNAL RECEPTION TEST.
RF DISTURBANCES.
S
ETTING OF OVERSPEED INDICATOR,
SCROLLING AND SETTING OF FUNCTIONS
12.0 and 13.0),
select parameter
.
.
To install the sensors on a metal bumper, you must use appropriate adapters (
!
.
Choose the suitable type of
For brackets "7" drill holes with a 18mm diameter, for brackets "8" drill holes with a 22mm and for
.
Sensors and plastic brackets can be painted to match the color of your bumpers.
.
Before drilling, inspect behind the bumper to check for any possible obstruction such as
!
iron struts and, in any case, be careful to avoid damaging parts behind the bumper.
.
H
14, select value 2
.
1
INSTALLER MANUAL
7.0 - INSTALLATION OF SENSORS
supplied)
plastic br
acket and mark the center of the holes to drill.
brackets "10" drill holes with a 24mm diameter.
18
1
+
7
22
+
8
1
24
+
1
10
H = 400 - 500 mm
1
+10°
8
not
.
4 x
100
320
320
100
H = 500 mm H = 650 mm
10
-10°
0°
+0°
H = 350 mm
7
+10°
INSTALLER MANUAL - PAGE 07
Advertisement
Table of Contents
