Page 1
INSTALLATION CERTIFICATE The undersigned qualified installer attests to have personally fitted the here described system following the manufacturer instructions. By : KIT Parking Sensor 814W Type of product : Sold on : 814W ..............INSTALLATION AND Car : USE MANUAL ..........................
Page 2
BLACK BLUE BLACK-BLUE BLUE BLACK BLUE BROWN Sensor 1: rear with shortest cable. BLACK-YELLOW Sensor 4: rear with km/h longest cable. BLACK-BLUE BROWN 10 x...
Page 3
WINDSCREEN CORRECT POSITION DASHBOARD ALTERNATIVE MOUNTING TECHNICAL SPECIFICATIONS Supply voltage From 9 to 30 Vdc Current consumption when system working 100mA max. Service temperature range From -20°C to +70°C Ultrasound frequency 40Khz Control units and display communication frequency 434Mhz Software version reference (reported on control unit and display) SW07...
USER MANUAL CONTENTS - PRELIMINARY ADVICE.................... PAGE 02 2.0 - SYSTEM OPERATION USER MANUAL Remember to always look behind the vehicle while parking. - SYSTEM OPERATION....................PAGE 03 Small obstacles or objects with low reflectance might not be detected. 2.1 - Detection Zones...................... PAGE 03 2.2 - Rear sensors......................
2.2 - REAR SENSORS 4.0 - DISPLAY The sensors are activated when reverse gear is engaged; an audible signal warning and the downward arrow icon that lights up on the display will indicate the sensors are active The following icons will be displayed according to operations. Obstacles are signaled by different audible tones and the lighting up of the relative detection zones and distance on the display.
INSTALLER MANUAL 6.0 - INSTALLATION OF SENSORS Use the supplied tie To install the sensors on a metal bumper, you must use appropriate adapters ( (15) or bolts supplied) secure the control units to the front bumper Choose the suitable type of plastic br acket and mark the center of the holes to drill.
7.0 - CONNECTIONS 8.0 - PAIRING OF CONTROL UNIT WITH DISPLAY When pairing, make sure reverse gear is disengaged no similar control units are activated in the surroundings Supply the display (turn vehicle ignition key to “ON). ress and keep pressed for about two seconds the two push-buttons on the display The letters “LE”...
10.0 - PROGRAMMING 11.0 - SETTING OF PARAMETERS PARAMETER RANGE SETTING Only expert users should modify these settings to avoid malfunctions of the parking Volume of buzzer 0, 1, 2 ( Ref.1 system. Detection range of front central sensors From 50 to 95 cm Detection range of rear central sensors Not used Supply the display (turn...
Select and set it by pressing one of the two push-buttons on the display for about 3 seconds The warranty is valid exclusively at authorized Gemini Technologies centers. Disengage reverse gear and turn ignition “OFF”.