Advertisement
3.3 - TIME-ACTIVATED SENSORS (
Check setting of function 12 (delay in deactivation of front
The front sensors can be activated by turning the ignition ON or by pressing the push-button with the
LED.
Operation is
directly related to the setting of the
To activate the sensors through the push-button, press it at the beginning of the manoeuvre; once you
have parked, press the push-button again to deactivate the sensors.
By modifying the
time setting
of the front sensors (function 12, preset value "00"), the front sensors will
work as follows:
!
If, within the preset time, no obstacle is detected in front of the vehicle, the sensors will
automatically be deactivated.
!
If, within the preset time, the obstacle is still detected, the sensors will remain active as long as the
obstacle is detected and will deactivate 3" after detecting the last obstacle.
!
If you need to use the front sensors again after the automatic deactivation, simply press the push-
button with the LED. The sensors will automatically deactivate 3" after detecting the last obstacle.
4.0 - TROUBLESHOOTING GUIDE
4.1 - LOW POWER SUPPLY SIGNAL
If, when the control unit is turned on, the battery level is too low to guarantee the accuracy of the
system, the buzzer will almost immediately give out a deep warning tone for 5".
This will inform the user that ALL the sensors are deactivated.
The driver will therefore know that he will have to do without the parking sensors.
4.2 - FAULTY SENSORS
If, when the control unit is turned on, one of the sensors turns out to be inoperative or not connected,an
audio signal will sound for 3".
If more than one sensor is inoperative, the number of the faulty sensors will be alternatively displayed
on the main control unit.
Sensor 1 inoperative.
One single faulty sensor alters the correct functioning of the whole parking
POSSIBLE CAUSE
Ice on sensors
Sensors mounted too low
Back part of sensors in contact with frame
PAGE 04 - USER MANUAL
odometer
not connected)
sensors
, "setting of
parameters").
parameters.
Sensor 2 inoperative.
system.
4.3 - OTHERS
SOLUTION
Clean the sensors
Use the angle brackets to tilt axe of sensors upwards
Create a separation between the sensors and the vehicle
INSTALLER MANUAL
5.0 - INSTALLATION OF SENSORS
To install the sensors on a metal bumper, you must use appropriate adapters (
!
Choose the suitable type of
plastic br
For brackets "6" drill holes with a 18mm diameter, for brackets "6a" drill holes with a 22mm
diameter and for brackets "8" drill holes with a 24mm diameter.
Sensors and plastic brackets can be painted to match the color of your bumpers.
+
6
1
1
+
6a
1
+
8
Before drilling, inspect behind the bumper to check for any possible obstruction such as
!
iron struts and, in any case, be careful to avoid damaging parts behind the bumper
H = 400 - 500 mm
H
1
8
1
supplied)
.
acket and mark the center of the holes to drill.
18
22
24
2 x
100
100
H = 500 mm
H = 650 mm
6
0°
6a
H = 350 mm
+10°
INSALLER MANUAL - PAGE 05
not
-10°
Advertisement
