Max EH-70FII Instruction Manual page 5

● Clean a power cord plug regularly. Dust on the plug could cause a fire.
● When disconnecting a power cord, be sure to hold a power plug. Do not pull on the
power cord, or the cord could be broken and cause a fire or electric shock.
● Do not install the instrument on the place that is not level or that is subject to
vibration. It could damage the instrument or cause an injury because it might fall or
drop.
● Wash your hands / body immediately with soap if the grease is attached on them
when replacing a staple cartridge.
● Use only specified AC adapter (AC100-240V, 50-60 Hz) appended to the instrument.
● Use the instrument indoor dry location. It could cause an electric shock or damage
the instrument when operating it in the high humidity place.
REQUEST
In order to prevent problems with the instrument, observe the following
precautions.
● Install this instrument away from the following places:
1. Any place that catches direct sunlight or is located close to a heat source.
2. Any place that has dust or high humidity.
3. Any place that is not level or that is subject to vibration.
4. Any place that the temperature goes below 0°C /32°F or over 40°C /104°F.
● Use only MAX No. 70FE Staple Cartridge.
● Use a dry cloth to clean dirt of the instrument. Do not use solvents (alcohol,
benzene, thinner, etc.) or a damp cloth.
● This machine does not staple when Case cap is opened because of safety.
Close Case cap correctly when stapling.
CAUTION
3