Accessories; Usb-Serial-Cable-F - OLIMEX IMX233-OLX-NANO User Manual

Open-source single-board linux computer

Table of Contents

iMX233-OLinuXino-NANO user's manual

Reset button – used to reset the board

Power button – when Linux is running pressing PWR_BUT will put the board in low power mode;

when powered by battery PWR_BUT is used to initially power up the board – and pressing the

board again after it is powered will put it low power mode

Recovery button – when powered by battery the recovery button is used to bring the processor to

normal power mode

512 (32M x 16) MBit DDR SDRAM – the exact memory used at the moment of writing is Xylinx

H5DU5xxxyyy

Green LED1

6.11 Accessories

Here you will find additional information for Olimex products you can use with OLinuXino-NANO

purchase

The cable for the U_DEBUG interface that can be purchased for additional cost has three cables. It

is important to specify in your purchase order whether you want the USB-SERIAL-CABLE-F

variant with male of female connectors.

You will need a drivers that can be downloaded from the page of USB-SERIAL-CABLE:

https://www.olimex.com/Products/Components/Cables/USB-Serial-Cable/USB-Serial-Cable-F/.

Page 29 of 36

Table of Contents

Imx233-olinuxino-nano