Using Bitburner; Building The Linux Image - OLIMEX IMX233-OLX-NANO User Manual

OLIMEX© 2015 iMX233-OLinuXino-NANO user's manual

2.5 Using BitBurner

IMPORTANT! MODIFYING THE FUSES IS IRREVERSIBLE PROCESS! BURNING THE
WRONG FUSES MIGHT DAMAGE OLINUXINO IRREVERSIBLY! BURNING WRONG
FUSES MIGHT CAUSE BOOT PROBLEMS!
BURN FUSES AT OWN RISK!
The bit burning is done via the USB of the computer connected to the USB HOST connector
OLINUXINO board and the BitBurner software. To be able to burn the fuses you will need to make
a custom cable that connects a USB with the USB of your connector.

2.6 Building the Linux image

Notes on building the official Debian Linux image might be found at the following blog post:
http://olimex.wordpress.com/2012/07/05/building-debian-linux-distribution-for-imx233-olinuxino/
The board is also supported in the main Archlinux kernel. More info might be found at the
Archlinux web here: http://archlinuxarm.org/platforms/armv5/olinuxino
The board has is supported in OpenWRT. More info might be found here:
http://wiki.openwrt.org/toh/olimex/imx233-olinuxino
There are a number of unofficial images and guides avialable. Few of the good ones are linked
Page 10 of 36