Table of Contents
Advertisement
Installation Procedure
CAUTION
• The indoor unit must be installed according to the
specified distances in order to permit accessibility from
each side, to guarantee correct operation, maintenance,
and repair of the unit.
The components of the indoor unit must be reachable and
removable under safe conditions for people and the unit.
• Do not hold the discharge while carrying the indoor unit
to avoid the possibility of breakage.
• You must hold the hanger plate on the corner and carry
the indoor unit.
Step 3 Optional: Insulating the body
of the indoor unit
If you install a cassette type indoor unit on the ceiling
when temperature is over 27°C and humidity is over
80%, you must apply an extra 10 mm thick polyethylene
insulation or a similar type of insulation to the body of
the indoor unit.
Cut away the part where pipes are pulled out for the
insulating work.
Insulate the end of the pipe and some curved area by
using separate insulator.
8
English
360_AC_Indoor_IM_AU_ENG_EN.indb 8
NOTE
• A: Reference for the outer circumference of the unit
(When insulating the body of the indoor unit, use A as
the reference for its outer circumference.)
Indoor unit type and models
360 cassette type
<L>
(947 x 947 x 365)
360 cassette type
<L+>
(947 x 947 x 365)
Step 4 Installing the indoor unit
When deciding on the location of the air conditioner the
following restrictions must be taken into account.
1 Determine the positions of the pipe and the drain hose
hole as shown in the pattern sheet, and drill the hole
with an inner diameter of 14 mm.
NOTE
• Since the diagram is made of paper, it may shrink or
stretch slightly due to temperature or humidity. For this
reason, before drilling the holes, be sure to maintain the
correct dimensions between the markings.
A
Dimensions
AC071KN4PEH
2610 × 215
AC071KN4DEH
AC100KN4PEH
AC100KN4DEH
AC125KN4PEH
2610 × 215
AC140KN4PEH
AC140KN4DEH
2016-05-13 오후 5:01:35
Hide quick links:
Advertisement
Table of Contents
