Charging And Storage - Shark WANDVAC WS632SM Series Owner's Manual

CHARGER
Plug the Charger into a wall outlet.
STORAGE POST
SIDE-BY-SIDE DOCK CHARGING
OPTION 1 – SIDE-BY-SIDE CHARGING DOCK
You can charge the hand vacuum while it is stored
beside the wand. First, detach the hand vacuum,
then slide the nozzle opening over the storage
post. Make sure the contacts on the hand vacuum
are aligned with the contacts on the storage arm.
When charging is complete and you need to use
the unit again, reattach the hand vacuum and use it
to lift the wand and nozzle off the dock plate.
NOTE: The main unit comes with a partial charge. For maximum runtime, charge fully before first use (approximately
3.5 hours). Leaving the unit plugged in will not damage battery life.
6 s h a r kc l e a n . my

CHARGING AND STORAGE

To remove the battery from the hand vac or
the charging post, press the release tabs on the
battery cap and slide out the battery. To reinstall,
slide the battery into the compartment in the
handle unit it clicks, or into, or into the slot in the
dock charging post.
1
CONTACTS
OPTION 2 – CHARGING HANDHELD VACUUM
To charge the handheld vacuum alone without the
dock, unplug the charger cord from the dock and
connect it directly to the port on the handheld
vacuum, near the nozzle opening.
BATTERY
CHARGING HANDHELD VACUUM
2