Shark WANDVAC WS632SM Series Owner's Manual page 10

1. To deep-clean the dust cup and the cyclone
filter, first push the dust cup lid open. Use
the wire handle to lift the cyclone filter
housing out of the dust cup.
Rinse or wipe clean the dust cup and let air-dry
for 24 hours.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught in the brushroll.
DIRT ENGAGE™ FLOOR NOZZLE FLOOR NOZZLE
10 s h a r kc l e a n . my
MAINTAINING YOUR VACUUM
CLEANING THE DUST CUP AND FILTERS
1
CLEANING FLOOR NOZZLE
1. Turn off the vacuum.
2. Press the nozzle release button to detach the
3. Using a coin, turn the four locks
4. Clear any blockages and remove any debris
5. Replace the cover by sliding the tabs into the
2. When the dust cup is completely dry,
reinsert the cyclone filter housing. Make
sure the wire handle on the filter housing is
tucked down. Press the dust cup lid until it is
completely shut, then close the dust cup."
nozzle from the wand.
counterclockwise to open, then lift off the cover
and tilt back the neck of the nozzle.
from the brushroll and floor nozzle.
slots. Press down firmly on all sides. Turn locks
clockwise to close, until they click into place.
2