Service Menu - List - Ring - Module List; Ervice Enu Ist Ing Odule Ist Odule I/O List - Notifier AFP-2800 Operator's Manual

Page 34
S M - L – R
ERVICE ENU IST
Once you have selected the module, a list of all inputs and outputs for that module will be displayed in a format
specific for the module type. The example below shows a the layout for an AZM-8 module which has 8 AZF inputs
and 4 programmable outputs.
MODULE I/O LIST
01 OCT 1999 14:44:37
USE BUTTONS TO SELECT AN I/O:
RING 1 MODULE 1
IDENTIFIED AS AZM-8
AZF I/P STATUS
Z01:I
Z02:IA
Z03:
Z04:F
Z05:
Z06:IF
Z07:
Z08:
ZONE 1, KITCHEN LEVEL 6
PREV NEXT
In the above example, the following abbreviations of STATUS apply.
Note: If the input is a non-alarm AZF, it will display an x when the INPUT is activated.
© N I P
OTIFIER NERTIA TY
www.PDF-Zoo.com
– M L – M
ING ODULE IST ODULE
A = 0
F = 0
I = 0
N = 0
O/P STATUS
o01:
o02: x
o03: x
o04:
CHANGE
TEST BACK
Status
Abbreviation
A
F
X
L , 2001
TD
firealarmresources.com
AFP-2800 - Fire Indicator Panel – Panel Operation
I/O L
IST
Actions:
•
Use the PREV and NEXT buttons to scroll
through I/O points.
(The points descriptor will display at the bottom of
the screen when each point is highlighted.)
• When highlighting an AZF input point, pressing the
TEST button will take you into the test menu for
AZF's (refer page 51). Which provide the options for
an Alarm Test and Fault test.
•
When highlighting an output point, pressing the
TEST button will take you to a test menu for
outputs where you can toggle the output on/off for
commissioning test purposes. Refer to page 52.
•
Pressing the CHANGE button will take you to the
Modify Point Screen (refer to page 41)
Meaning
Alarm
I Isolated
Fault
Activated
. . .
WWW INERTIA COM AU